Search results

Hey guys! I’m having a bit of a headache with my Hummer EV. I plugged it in overnight, expecting a full charge, but it decided to quit early and now it won’t charge at all. Plus, the check engine light is shining bright. I took it to the dealer, and they pulled some codes, but I have to go back...

Not yet! It’s still sitting in the lot waiting to be shipped.

Yeah, you’d think with so many available, the wait times wouldn’t be this bad.

I just prefer a cleaner look without the front badge. I’m making a few small changes to personalize it, and I want to be sure there aren’t any holes before I remove it.

This sounds like a clean way to do it. Did you have any trouble with leftover adhesive or was it easy to remove?

That’s exactly what I was hoping to hear, did you notice any residue, or did it come off clean?

I had a similar issue when I got mine, in the end, they just rebooted the truck, and it was fixed.

I have a couple dust nibs but nothing more than I found on a brand new merc and Lincoln.

Disconnect the sensor, spray the connector with electrical contact cleaner, and apply dielectric grease before reconnecting. Just try this.

GM has been making thermally controlled batteries since 2010 in the volt. Those are still going strong.

Yeah the BlackVue DR900X-2CH is good for dashcams, you can pair it with a Thinkware Radar Module for impact alerts and a Vantrue voice deterrent system for added security.

I’ve seen a few pop up in California and Texas when I travelled few months back... How’s the range and charging experience so far? any surprises?

Even a small PSI change really matters on a heavy vehicle like the Hummer EV. 41 PSI was definitely too low so the 6.5 noise level makes sense. I agree with @Eric the correct is 44 psi. It shows how much tire pressure affects the ride. correct tire pressure helps with range and tire life so it's...

I want to know if the front GMC badge is only taped on or if there are indents or placement holes behind it, has anyone taken it off? Although it appears that the remaining body emblems can be removed without any problems, I don't want the grille to end up with holes. I'd love to know how it...

So I’m back! Just wanted to drop a quick update. I decided to do a hard reset by disconnecting the ground on the 12v battery for about 30 minutes - yep, that’s a thing! After plugging it back in, I followed the prompts to tweak the windows and then took a quick ten-minute spin. No check engine...

Just got my 2024 Hummer! Loving it, but I'm already looking for ways to lift it higher. I noticed there are ride height sensors in the front and rear of the tire wells. I'm thinking of trying to make a set of adjustable links to see if I can get more lift out of the suspension. This thing just...